SECTION 4 OPERATING Page 32 OPERATING TECHNIQUES Always feed the blade into the ground gradually until the desired depth of cut is obtained. When selecting the gear range and determining the depth of cut, allow for an increase in resistance as the load increases. When raising the blade at the end of a cut, do it gradually to avoid an abrupt ridge or bump in the path of the tractor. Move material downgrade whenever possible to take advantage of the reduced effort required (Fig. 4.29). Fig. 4.29. Moving Material Downgrade Two methods of cutting down a pile or hill are shown in Fig. 4.30. Type of material and local conditions may dictate which method is preferred.
Further information is included in “BREAKING PILES AND SPREADING” When using Method l, never allow the high face to become a hazard to the operator or machine. With the tractor at right angles to the face, raise the blade and dislodge the high bank before returning to the original direction of cut. When using Method 2, make the cut wide enough to avoid trapping the tractor. WARNING! Avoid high overhangs. Ramp up and remove the top layers first. Avoid high banks. Operate the machines as far away from the trench as possible or cave-in may result. Fig. 4.30. Cutting Down a Pile or Hill 1 – Method 1 2 – Method 2 TD-40C DRESSTA