DRESSTA Co. Ltd. TD-40C98/1E — 4.19. OPERATING TECHNIQUES

OPERATING SECTION 4 Page 33 OPERATING TECHNIQUES A side-hill cut can be started more easily if a small bench cut is first made as shown in Fig. 4.31. Then, when digging as in Fig. 4.32, keep the inside (uphill) surface slightly lower to gain greater tractor stability. Tilting the blade will provide this type of cut with less effort on the operator's part. Fig. 4.31. Side-Hill Cut 1. Cut I 2. Cut II 3. Cut III Fig. 4.32. Side Hill Cut 1. Level 2. Lower Surface Always cut the shelf wide enough to provide solid support for equipment using it later. If possible, move the material downhill to gain the advantage of gravity, reduced effort and increased tractor stability.

Soft soil or shallow slopes may allow the side hill cut to be made as shown in Fig. 4.33. Increased stability is realized by running the uphill track inside the ridge left by the first cut. Cuts 3, 4 and 5 illustrate the completion of the shelf. DRESSTA TD-40C