SECTION 4 OPERATING Page 34 OPERATING TECHNIQUES Fig. 4.33. Shallow Slope Side Hill Cut Once again, pushing the loosened material to the lower side of the slope will normally reduce time and cost. Do not push material beyond the point required to retain firm track support. Fig. 4.34. Slope Edge Operation When backing up, do not raise the blade as this puts extra weight on the front idlers causing greater track penetration. Let the blade float as you back away from the edge of soft fills. Initial work on steep hillsides can be safer by either securing the tractor with a winch to a suitable uphill anchor point or by operating a tandem arrangement as shown in Fig. 4.35. Fig. 4.35.
Operating a Tandem Arrangement TD-40C DRESSTA