OPERATING SECTION 4 Page 39 OPERATING TECHNIQUES Fig. 4.44. Backdragging 4.19.4. RIPPING 4.19.4.1. Prior to Operation Before operating the ripper proceed as follows: 1. Check all mounting hardware for torque. 2. Check hydraulic connections for leaks. 3. Check the condition of the ripper, bits, mounting hardware for completeness and torque. 4.19.4.2. Ripping Techniques When starting ripping lower the ripper teeth slowly to required depth. Ripping of rock material must be performed in direction of easier ripping what may be established by carrying out test ripping in various directions and under various angle of inclination of the shanks.
During test ripping lower the shank to half of working depth. Machine efficiency can be improved when several centimeters of loose material is left on solid rock. Ripping should be performed at a depth the best results are obtained without overloading the engine. Keep loose ground level and horizontal as mach as possible. Never make turns with the machine with ripper teeth are at full depth in rocky ground. Use the common sense when working in hard ground not to damage the ripper and the machine. Do not accelerate the machine and simultaneously lower the ripper teeth into the ground – this will damage the ripper.
Pay attention not at allow rear of the machine to lift off the ground during ripping operations, as this decreases traction and accelerates wear of track system. Use new and sharp bits for hard ground. 4.19.5. COLD WEATHER OPERATION Start the engine as described in “STARTING THE ENGINE” and then proceed as follows: move slightly and slowly ripper control to warm oil in hydraulic cylinders. raise the ripper at max. height and then lower it slowly until it rests on the ground. increase gradually pressure in ripper cylinders by keeping the control lever in LOWER position until rear of the machine is off the ground. DRESSTA TD-40C