Check Oil Level in Engine Oil Pan, Add Oil OPERATION The parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the temperature to go down before starting the operation. Make sure that the machine is parked on a horizontal position before you check the oil level. Remark After the engine has been operated, wait for at least 15 minutes after stopping the engine before checking the oil level. 1. Stop the engine and wait for the temperature of all parts to go down. 2. Open the inspection cover on the right side at the rear of the machine. 3. Take out dipstick (G) and use a cloth to wipe off the oil. 4.
Fully insert dipstick (G) into filler pipe (F) and then remove it. 5. The oil level should be between the H and L marks on dipstick (G). If the oil level is below the L mark, add oil through oil filler (F). The dipstick has level markings on both sides. Side 1: ENGINE STOPPED: Indicates the levels for mea- suring when the engine is stopped. Side 2: ENGINE IDLING: Indicates the levels for mea- suring when the engine is idling. When measuring the oil level, measure with the engine stopped and use the side of the dipstick marked ENGINE STOPPED. 6. If the oil is above the H mark, drain the excess engine oil from drain plug (P) and check the oil level again. 7.
If the oil level is correct, tighten oil filler cap (F) securely and close the inspection window. Remark Checking the oil level with the engine idling can be done if the following precautions are taken: Check that the engine water temperature gauge shows in the green range. Use the side of the dipstick marked “ENGINE IDLING.” Remove the oil filler cap. Make sure that the machine is parked on a horizontal surface. WA500-3LK 2-47