Komatsu — Installing the Bucket

4. Select the number of shims so that clearances (A) between bucket hinge boss (4) and lift arm boss (1) are less than 1.0 mm (0.04 in). OPERATION 5. Assemble the shims selected in Step 4; align the pin holes; then insert bucket hinge pin (5). Coat with grease to prevent damage to the dust seal when inserting the bucket hinge pin. Use a bucket hinge pin that has a grease hole. 6. Install mounting bolt (6). 7. Move cord ring (2) down to the groove. 8. Use the same procedure as in Steps 1 to 7 to install the bucket link pin. Assemble a pin that has no grease hole at the bucket link. 9. Coat the bucket hinge pin and bucket link pin with grease. For details, see “Lubricating” on page 3-50.

For additional details about removing and installing the bucket, contact your Komatsu distributor. WA500-3LK 2-95