Komatsu — After Storage

After Storage OPERATION Remark If the machine has been stored without carrying out the monthly rust-prevention operation, contact your Komatsu distributor before returning the machine to operation. Before returning the machine to operation after a long-term period of storage, do the following procedure. Wipe off the grease from the hydraulic cylinder rods. Add oil and grease at all lubrication points. When a machine is stored for a long period, moisture in the air mixes with the oil. Check the oil before and after starting the engine. If there is water in the oil, change the oil. Check that there is no rust on the engine pulley and no abnormality in the belt.

If there is excessive rust on the belt contact surface of the pulley, remove it with a wire brush. If the belt is loose, adjust the belt tension to ensure that there is no slipping. For details about adjusting the belt tension, see “Check Alternator Belt Tension, Adjust” on page 3-48. WA500-3LK 2-113