Komatsu — Bleeding Air from Fuel Line

OPERATION TROUBLESHOOTING When Machine Runs Out of Fuel Always watch the fuel level and be careful not to run out of fuel. This engine is made off higher precision parts than on the conventional fuel injection pump and nozzle. If dirt gets into the fuel system, it will cause problems. If there is any dirt stuck to the fuel line, use fuel to wash it off. Be careful when opening the air bleed plug at the fuel filter head and the air bleeder of the supply pump. The system is still under pressure and fuel may spurt out. When starting the engine after running out of fuel, check carefully that the area around the engine is safe before cranking the engine.

When starting the engine after running out of fuel, fill with fuel and bleed the air from the fuel system before starting the engine. If the engine has stopped because of lack of fuel, it is necessary to use the priming pump to bleed the air completely from the fuel circuit. Bleeding Air from Fuel Line 1. Remove fuel filter cartridge (1); fill the inside of the filter with clean fuel, being careful not to let dirt or dust get into the filter; and then install the fuel filter cartridge. Add fuel from small hole (A) (dirty side) at eight places. Do not add fuel from hole (B) (clean side) at the center. If clean fuel is not available, go to Step 2. 2.

Loosen air bleed plug (2) at the fuel filter head. 2-114 WA500-3LK