17. Add coolant mixed with antifreeze until it overflows from the water filler. MAINTENANCE Determine the proportions of antifreeze and water according to the “Water and Supercoolant Mix Ratio Table” on page 3- 25. 18. To bleed air from the cooling system, run the engine at low idle for five minutes, and for a further five minutes at high idle. Leave the radiator cap off while running the engine. 19. Open drain plug (6) to drain the coolant from subtank (5); wash the inside of the subtank. 20. Add coolant until the coolant level is between the FULL and LOW marks. 21. Stop the engine and wait three minutes. 22. Add coolant until the coolant level is near the coolant filler port. 23.
Tighten the radiator cap. 24. Check the coolant level and add more coolant, if necessary. WA500-3LK 3-27