Komatsu — Check Transmission Oil Level, Add Oil

4. Fully insert dipstick (G) into filler pipe (F) and then remove it. MAINTENANCE The oil level should be between the H and L marks on dipstick (G). If the oil level is below the L mark: add oil through oil filler (F). If the oil level is above the H mark: drain the excess engine oil from drain plug (P) and check the oil level again. If the oil level is correct: insert dipstick (G) in the dipstick guide and tighten the cap. Remark It is also possible to check the transmission oil level when the engine is running at low idle. Use the Check Transmission Oil Level When Engine is Idling instructions. Check Transmission Oil Level When Engine is Idling Conditions:

When checking after engine left idling (when heat is balanced in whole transmission). User operating continuously (check during lunch time or check during change of shift). Run at idle for at least 15 minutes and then leave. Check when torque converter oil temperature gauge is in middle of bottom scale. Conditions: When checking after raising temperature with stall When shipped from factory, etc. Run at idling for five minutes. Check at point when stall temperature rises and torque oil temperature gauge is at 3rd segment from left. WA500-3LK 3-29