Komatsu — Check Alternator Belt Tension, Adjust

MAINTENANCE Check Parking Brake 1. Set the machine on a dry, downhill slope. 2. Press the parking brake switch to the ON position and check if the parking brake holds the machine in position. Position (a): ON Parking brake is actuated and parking brake pilot lamp illuminates. Position (b): OFF The parking brake is released. 3. If there is a problem, contact your Komatsu distributor. Check Alternator Belt Tension, Adjust Checking The standard deflection (a) between the drive pulley and alternator pulley is about 13 to 16 mm (0.51 to 0.63 in) when pressed by a thumb force of 98.1 N (22.1 lbf) at a point midway between the drive pulley and the alternator pulley. Adjusting 1.

Remove cover mounting bolts (6) in two places and remove the cover. 2. Loosen bolts (1), (2), and (5) and then turn nut (4) to adjust the tension of the belt. 3. After adjusting, tighten bolts (1), (2), and (5) to secure alternator (3). 4. Reinstall the cover. Make sure that no part of the cover touches any moving part of the alternator. 5. Check each pulley for damage and wear of the V-groove. Be particularly careful to check that the V-belt does not touch the bottom of the V-groove. If there is an abnormality, contact your Komatsu distributor for replacement of the pulley.

If the belt has elongated and there is no more allowance for adjustment or if the belt is cut or cracked, replace the belt. When adjusting the V-belt, do not press the alternator directly with a bar; use a piece of wood between the bar and the V-belt. If you have replaced the V-belt, operate the machine for one hour and then adjust the belt again. The V-belt elongates when first used. 3-48 WA500-3LK