Komatsu — Check for Loose Wheel Hub Nuts, Tighten

Check Air Conditioner Compressor Belt Tension, Adjust MAINTENANCE Checking The standard deflection (a) between the air conditioner compressor pulley and the drive pulley should be 8.5 to 11 mm (0.33 to 0.43 in) when pressed with a thumb force of approximately 58.8 N (13.2 lbf) at a midway point. Checking When Changing the V-Belt The standard deflection (a) between the air conditioner compressor pulley and the drive pulley should be 6 to 8.5 mm (0.24 to 0.33 in) when pressed with a thumb force of approximately 98.0 N (22.0 lbf) at a midway point. Adjusting 1. Loosen bolt (1). 2. Loosen locknut (2). 3.

Turn adjustment bolt (3) to adjust the belt tension so that the deflection (a) is the specified value. 4. Tighten locknut (2). 5. Tighten bolt (1). 6. Check each pulley for damage and wear of the V-groove. Be particularly careful to check that the V-belt does not touch the bottom of the V-groove. 7. Check for wear of the V-belt. If the belt has elongated and there is no more allowance for adjustment or if the belt is cut or cracked, replace the belt. When adjusting the V-belt, do not press the alternator directly with a bar; use a piece of wood between the bar and the V-belt. If you have replaced the V-belt, operate the machine for one hour and then adjust the belt again.

The V-belt elongates when first used. Check for Loose Wheel Hub Nuts, Tighten If wheel hub bolts (1) are loose, tire wear will increase and accidents might happen. 1. Check for loose nuts and tighten, if necessary. When checking for loose nuts, always turn the nuts in the tightening direction. Tightening torque:. . . . . . . . . . . 471 ±49 N•m (347.39 ±36.14 lbf ft) 2. If any stud bolt is broken, replace all the stud bolts for that wheel. WA500-3LK 3-49