MAINTENANCE Clean Engine Breather Element The parts and oil are at high temperature after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before cleaning the engine breather. When using compressed air, there is a hazard that dirt may be blown up and cause serious injury. Always use safety glasses, dust mask, or other protective equipment. 1. Wipe away any dust around the breather. 2. Remove breather (1). 3. Clean the breather body with light oil or cleaning oil, and dry it with compressed air. 4. Replace the O-ring with a new one. Coat a new O-ring with engine oil; set it; then install breather (1).
Check Alternator, Starting Motor The brush may be worn or have no grease on the bearing; contact your Komatsu distributor for inspection or repair. If the engine is started frequently, carry out inspection every 1,000 hours. Check Engine Valve Clearance, Adjust A special tool is required for removing and adjusting the parts; ask your Komatsu distributor for service. Check Brake Disc Wear A special tool is required for checking and adjusting the parts; ask your Komatsu distributor for service. Clean and Check Turbocharger If there is carbon or oil sludge stuck to the blower impeller, it will reduce the performance of the turbocharger or cause it to break.
Ask your Komatsu distributor to carry out the cleaning. Check Play of Turbocharger Rotor Contact your Komatsu distributor to have the rotor play checked. 3-70 WA500-3LK