Komatsu — Procedure for Setting Greasing Time

Procedure for Setting Greasing Time OPTIONS, ATTACHMENTS When setting the various items, the value is not input directly. Select the code number from the Set Code table; see “Set Code Table” on page 5-10. 1. Stop the working machine on flat, hard ground and stop the engine. 2. Set the safety lock lever at the LOCK position. 3. Set the starting switch at the ON position. 4. Turn the starting switch ON and start the engine. 5. Press the LEVEL and ITEM keys at the same time to set to the setting mode. 6. Press the ITEM key one or more times to select the item to be set. Each time the ITEM key is pressed, the setting item is changed: a b c a. 7.

When the item to be set flashes, press the LEVEL key. The set item and numeral are displayed alternately (a 0 a 0). 8. Refer to the Set Code table and press the ITEM key one or more times to select the code number to be set. Each time the ITEM key is pressed, the code number (numeric portion) goes up by 1. 9. When the code number to be set flashes, press the SET key to confirm the setting. 10. Repeat Steps 7 to 9 to set all of the items (a, b, and c). After completing the setting, press the ESC key to exit the setting mode. Remark Even if only one item is being changed, always make changes according to Steps 5 to 8 and press the ESC key to exit the setting mode.

If the power is turned ON, the count for the greasing interval will start immediately after the ESC key is pressed. Part of the display segment flashes to indicate that the system is counting. After setting, the set value is retained in memory even if the power is turned OFF. WA500-3LK 5-11