Komatsu — Replacing Grease Cartridge

OPTIONS, ATTACHMENTS Checking Amount of Grease 1. Turn the auto-greasing starting switch (1) ON. 2. Check the pilot lamp (2) on the main monitor. If it flashes at 1- second intervals, the grease cartridge is empty. Replace the cartridge with a new one. Replacing Grease Cartridge Bleeding air from the pump is dangerous because of the high pressure. Ask your Komatsu distributor to bleed the air. Be careful of the force exerted by spring (2) which is located inside the cover. Remark After replacing the cartridge, make sure to reset the number counter on the controller. If you have a problem, see “Troubleshooting Auto-Greasing System” on page 5-14. 1.

Remove cover by turning cartridge cover (1) approximately 60 degrees to the left. 2. Remove grease cartridge (3) by turning it to the left. Do not detach seal cap (4) at this time. 5-12 WA500-3LK