OPTIONS, ATTACHMENTS Precautions for Steering with Joystick If the machine and transmission cannot be operated normally with the joystick, or if the warning lamp lights up, use the brake to stop the machine. Turn off the joystick ON/OFF switch and move to a safe place by using the steering wheel and directional lever. Before restarting the operation of the machine, find and repair the problem part and confirm that the function is normal. For troubleshooting and repair, contact your Komatsu distributor. Never operate the machine before it is repaired completely.
Do not move the joystick to the left or right until the N display on the machine monitor FNR display lights up to indicate that the joystick is ready. The joystick controller senses the neutral position of the joystick. If the joystick is moved before the neutral position is sensed, an error is detected and the caution lamp flashes; the joystick steering system does not work. If an error is indicated, turn off the joystick ON/OFF switch, then turn it on again. If the machine is steered with the steering wheel, its turning angle is fixed when turning of the steering wheel stops.
If the machine is steered with the joystick and the joystick is held in a turning position, the machine is steered to the articulate end. Since the feel of steering with the joystick is different from using the steering wheel, be very careful until you are accustomed to the joystick. If the F or R button at the joystick head is pushed and held more than 30 seconds, a short circuit is sensed and an error is indicated. Touch these buttons only when required. If the directional lever is not at the neutral position when the joystick ON/OFF switch is turned off, the neutral interlock circuit prevents it from turning to the joystick lever side.
Since the transmission is kept at the neutral position, the machine cannot move either forward or in reverse. In this case, turn the directional lever to the neutral position, then turn off the joystick ON/OFF switch. If there is a problem with the electric circuit of the joystick steering system or transmission control system, the central caution lamp (red) on the left side of the main monitor flashes to notify the operator of the problem. Since both steering system and transmission are set in the respective neutral positions, turn off the joystick ON/OFF switch, then drive the machine with the steering wheel and the directional lever. 5-24 WA500-3LK