Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH (HORIZONTAL PIN TYPE) Replace the teeth before the wear reaches the adapter. WARNING 4 - 31 CHECK ELECTRICAL INTA Before the start of the cold sea son (once a year), contact your Komatsu distributor to hav e the electrical intak e air heater repaired or checked for Remove the electrical intake air heater from the engine intake manifold, and check it for pos sible disconnections and dirt. When inspecting and replacing the electrical intake air heater, replace the gasket with ne It is dangerous if the work eq replacing the teeth.

uipment is mistakenly moved when Set the work equipment in a stab le condition, stop the engine, then set lock lever (1) securely to the LO CK position (L). As the locking pin is knocked ou t with force, there is danger that the pin may fly out. Check that there is no one near the machine. he replacement operation, so always ther protective equipment. Broken pieces may fly during t wear safety glasses, gloves, or o 1. Set block (3) under bottom f ace of the bucket so pin (1) can be removed. Turn the starting seconds after stopping the levers, check that work equ lever to the LOCK position ( is horizontal.

switch to the ON position within 15 engine, fully operate the control ipment is stable, then set the lock L). Set so bottom face of the bucket 2. Place a bar on the head of p in (1), hit the bar with a hammer to knock out the pin, then rem ove tooth (2). REMARK If the bucket teeth cannot b e safely removed by this mothod, have your Komatsu distribut or replace the bucket teeth.