Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE 2. Starting engine Start the engine according to "STARTING ENGINE (PAGE 3-94)" keep running the engine at low idle for 10 minutes, and carry out the following procedure. 4 - 37 BLEEDING AIR FROM HYDRAULIC SYSTEM For details, see "STARTING ENGINE (PAGE 3-94)". If it is necessa ry to refer to the items for starting the engine, moving the machine off, steering, or stopping, see the OPERATION section. NOTICE Bleed the air as follows. 1. Pump (work equipment, swing) 2. Work equipment circuit Run the engine at less than 1000 rpm, and operate the cylinders slowly. o the end of the stroke. , operate particularly slowly.

Do not suddenly stop and cause the cylinder pressure to rise or operate t When operating the cylinder for the first stroke (extending and retracting) When operating the cylinder for the first stroke, there is a large amount of air inside the circuit, so the work equipment will not move for at least 10 seconds. Be careful not to operate the lever to the en d of the stroke. se a clean oil can. Use clean oil of NAS7 class or above when filling the pump. Be sure to u Carry out Steps 1 - 3 below to bleed the air. If necessary, carry out Steps 4 - 6 in addition. 1. Bleeding air from pump 1) Loosen air bleed plug (1) and check that oil oozes out from the air bleeder (3).

2) If oil (4) does not ooze out, remove the pump case drain hose and elbow, then fill the inside of the pump case with hydraulic oil through drain port (2). If the mouthpiece is lower than the surface of the oil in the hydraulic tank, oil will flow out from the drain hole when it is removed, so secure the mouthpiece of the hose at a position higher than the level of the oil in the hydraulic tank. 3) After completing the air bleed operation, tighten air bleeder (1) and install the drain hose. NOTICE If the drain hose is installed first, oil will spurt out from plug (1) hole.

If the pump is operated without filling the pump case with hydraulic oil, abnormal heat will be generated and this may cause premature damage to the pump. 3. Bleeding air from cylinders 1) Run the engine at low idle, and extend and retract each cylin not moved to the end of its stroke. (Stop the cylinder approx 2) Next, operate each cylinder 3 to 4 times to the end of its stro 3) Finally, operate each cylinder 4 to 5 times to the end of its st der 4 to 5 times, taking care that a cylinder is . 100 mm (3.9 in) short of its stroke end) ke. roke to completely remove the air.

NOTICE If the engine is run at high speed immediately after startup or a cylinder is pus hed up to its stroke end, air taken inside the cylinder may cause damage to the piston packing.