. MAINTENANCE MAINTENANCE PROCEDURE NOTICE Do not operate the swing under any circumstances. 2) If the oil does not ooze out, stop the engine, remove drain hose (1), then fill the motor case with hydraulic oil. 4 - 38 4. Bleeding air from sw ing motor (bleed the air on ly when the oil inside the swing motor c ase has been drained) n drained from inside swin g motor at low idling, loosen drain of bleeding air, install drai n hose ( t low idle, and slowly swing the upp er structure at least 2 times unifo rmly to the left and right. NOTICE the swing motor, the motor bearings may be damaged.
If the air is not bled from the swing motor, the motor bearings may be When replacing the trave l motor safety valve, please c ontact y our Komatsu distributor to have it re placed and to have the air bled. 5. Bleeding air from att achment (when installed) If an attachment has (approx. 10 times) u been installed, run the en gine at l ow idling and operate the attac hment pedal repeatedly ntil the air has been bled f rom the attachment and circuit. NOTICE If the method of bleedin g the air from the attachment itself is specified by the manufacturer, blee d the air according to the specified procedure.
After completing the air bleeding operation, stop the e ngine, an d leave the machine for 5 minutes before starting operations. This will remove the air bubbles in the oil inside the h ydraulic cylinders. as been spilled. Check that there is no le akage of oil and wipe off any oil that h as been