. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE (2) one turn. lever and set to out from air bleed wait for at least 5 minutes before starting 4 - 39 6. Bleeding air from travel motor f t he piping has been remove oto rcuit, bleed the ai r after reassembli ng. To bleed the air, run the follows. low idling. air, run engine at lo w idling and do as 1) Start the engine and run at low idling. 2) Remove travel motor cover (1), then lo osen a ir bleed plug NOTIC Do not loosen plu g (2) mor e than one t 3) FORWA RD and REVERS E 4 - 5 time 4) When n o more cloudy whi te oil come plug (2), tighten air bleed p 5) Install th e travel motor cov 7.
1) After co mpleting ngine operatio ns. This will allow t he bubbles in the o il insid e the tank 2) Check th at there is no leak age of oil, a nd wip e up an y oil t hat h