. MAINTENANCE MAINTENANCE PROCEDURE METHOD FOR RELEASING INTERNAL PRESSURE IN HYDRAULIC CIRCUIT RELEASING PRESSURE FROM WORK EQUIPMENT CIRCUIT, SWING CIRCUIT, TRAVEL CIRCUIT WARNING 4 - 40 Th e hydraulic system is always u nder internal pressure, so when inspecting or replacing the pipin g or hoses, always release the pressure in the circuit before starting. If the pressure is not released , high pressure oil may s purt out and cause serious personal injury. Th e parts and oil are at high temp erature after the engine is stopped, and may cause serious burn s.
Wait for the temperature to go down before starting the op When the oil filler cap is removed , oil may spurt out, so turn the cap slowly to release the pressur e before removing the cap. 1. S top the machine on firm h orizontal ground, lower the work e th quipment to the ground as s hown in the diagram on the right, en stop the engine. REE position (F). nt control lever to the full stroke pping the engine. at the ON position. Set the lock lever at the F 2. O perate each work equipme w ithin 5 - 6 seconds after sto Leave the starting switch 3. R emove the cap of the hydr aulic tank. rox. 10 seconds, then stop the engine again. ore than 1000 rpm. ontrol levers to the HOLD position. 4.
S tart the engine, run for app rox. 10 seconds, then stop the Do not run the engine at m Set the work equipment c ontrol levers to the HOLD position. 5. O perate each work equipme nt control lever to the full stroke within 5 - 6 seconds afte Repeat Steps 4 - 5 three t imes. RELEASING PRESSURE IN ACC UMULATOR CIRCUIT After stopping the engine, set loc k lever to the FREE position, then operate each work equipment c ontrol lever 3 - 4 times to the end of the stroke. After 1 minute, the internal pressure will be relieved. Do not loosen any piping until at least 1 minute has passed after relieving the internal pressure .