Toyota — YUASA

2-49 TROUBLESHOOTING Estimated cause Check method Standard Remedial action Thermal relay (THR) actuation as soon as charging starts TF insulation defect or short-circuit in coil TF insulation inspection Measurement terminals: Between each coil terminal and frame Inspection of short-circuit between pri- mary and secondary coil of TF OK: 3 MΩ or more NG: 3 MΩ or less OK: 3 MΩ or more NG: Less than 3 MΩ TF replacement Dch defect (short-circuit) Inspection of Dch forward and reverse resistance Measurement terminals: Both termi- nals of Dch (Anode - Cathode) Anode Cathode Forward: Anode − Cathode + Reverse: Anode + Cathode − OK: Forward: Over 10 kΩ Reverse: ∞ Ω NG: Forward: 0 Ω Reverse:

0 Ω Dch replacement Charging does not start even when the CHARGE ON/OFF switch is pressed to ON. (The timer does not operate.) AC power service interruption or lacking phase Voltage measurement at input recep- tacle Measurement terminals: Between receptacle terminals OK: 200 to 230 V (Charger for 200 V) 340 to 460 V (Charger for 400 V) NG: 0 V Repair after checking the cause for lacking phase Microcomputer timer (BMT) defect AMT inspection Measurement terminals: AMT 2-3 in wiring diagram OK: 0 V NG: 200 V (Charger for 200 V) 400 V (Charger for 400 V) AMT replacement Open circuit in MSch coil MSch coil conduction inspection Measurement terminals: MSch A -A 1 2 OK: See the service standard NG:

∞ Ω MSch replacement THR contact defect THR contact inspection Measurement terminals: THR 95-96 OK: Non-operated state: 0 Ω Operated state: ∞ Ω NG: Non-operated state: ∞ Ω THR reset lever opera- tion or MSch ASSY replacement Abnormal noise from MSch MSch contact rough- ening Visual inspection of MSch contact NG: Excessive roughen- ing or burn of contact surface MSch replacement Dust entrance or cor- rosion at movable part Visual inspection of MSch contact NG: Dust accumulation or corrosion on mov- able contact MSch con- tact correc- tion or MSch replacement