Doosan Mega 500-V (Tier II) — Fault Code Information

S0802195K Page 40 Electrical System Fault Code Light J1587 PID(P) SID(S) FMI J1939 SPN FMI Reason Effect 234 Red P190 0 190 0 Engine speed signal indicates engine speed is greater than 2730 rpm. Fuel shutoff valve closes until engine speed fails to 2184 rpm. 235 Red P111 1 111 1 Coolant level signal indicates coolant level is below the normal range. Progressive power derate with increasing time after alert. If Engine Protection shutdown feature is enabled, engine will shut down 30 sec. after red light starts flashing.

237 Yellow S030 2 644 2 Duty cycle of the throttle input signal to the primary or secondary engine for multiple unit synchronization is less than 3percent or more than 97 percent. All engines (primary and secondary) are shut down with increasing time after alert if harscoupled. Only secondary engine are shut down with increasing time after alert if soft coupled. 241 Yellow P084 2 84 2 The ECM lost the vehicle speed signal. Engine speed limited to Maximum Engine Speed without vehicle speed sensor parameter value cruise control, gear-down protection and road speed governor will not work (automotive only) 242 Yellow P084 10 84 10 Invalid or inappropriate vehicle speed signal detected.

Signal indicates an intermittent connection or VSS tampering. Engine speed limited to Maximum Engine Speed without vehicle speed sensor valve cruise control, gear- down protection and road speed governor will not work (automotive only 245 Yellow S033 4 647 4 Less than 6 VDC detected at fan clutch circuit when on. Indicates an excessive current draw from the ECM or faulty ECM output circuit. The fan may stay on at all times. 254 Red S017 4 632 4 Less than 6 VDC detected at FSO circuit when on. Indicates an excessive current draw from the ECM or a faulty ECM output circuit. The ECM turns off the FSO supply voltage. The engine will shut down.

255 Yellow S017 3 632 3 Externally supplied voltage detected going to the fuel shutoff solenoid supply circuit. None on performance. Fuel shutoff valve stays open. 285 Yellow S231 9 639 9 The ECM expected information from a multiplexed device but did not receive it soon enough or did not receive it at all. At least one multiplexed device will not operate properly. 286 Yellow S231 13 639 13 The ECM expected info from a multiplexed device but only receive a portion of the necessary information. At least one multiplexed device will not operate properly. 287 Red S091 2 91 19 The OEM vehicle electronic control unit (VECU) detected a fault with its throttle pedal. The engine will only idle.