Komatsu — CHECK LEVEL OF BATTERY ELECTROLYTE

. MAINTENANCE MAINTENANCE PROCEDURE CHECK LEVEL OF BATTERY ELECTROLYTE Perform this check before operating the machine. WARNING the NOTICE When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. 5. If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (1) and add distilled water to the U.L line. 6. After adding distilled water, tighten cap (1) securely. REMARK If distilled water is added to above the U.L. line, use a syringe to lower the level to the U.L. line.

Neutralize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your Komatsu distributor or battery maker. 4 - 55 Do not use the battery if the batter y electrolyte level is below the LOWER LEVEL line. This wil l accelerate deterioration of inside of the battery and reduce th e service life of the battery. In addition, it may cause an ex plosion. sparks near the battery. The battery generates flammable g as and there is danger of explosion, so do not bring fire or sparks near the b Battery electrolyte is dangerous. If it gets in your eyes or on your skin, wash it off with a large amount of water and cons doctor.

When adding distilled water to th e battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If leak and cause damage to the paint surface or corrode other parts. electrolyte level is too high, it may leak and cause damage to the paint surface or corrode oth Inspect the battery electrolyte lev el at least once a month and follow the basic safety procedures give n below. When Checking Electrolyte Level from Side of Battery If it is possible to check the electr olyte level from the side of the battery, check as foll 1 2 3 4 . Open the engine hood and lo ck it securely with the hood support lever. E 3-32)".) (See "ENGINE HOOD (PAG .

Open the battery inspection c over and lock it in position securely with the cover s (See "BATTERY INSPECTIO N COVER (PAGE 3-34)".) top of the battery. area around the electrolyte level lectrolyte level is between the WER LEVEL (L.L.) lines. dry cloth, static electricity may . Remove the seat installed on . Use a wet cloth to clean the lines and check that the e UPPER LEVEL (U.L.) and LO If the battery is wiped with a cause a fire or explosion.