43.2 General Fault Cause Remedy Coupling head, single line Compressed air escapes at Sealing surfaces defective. Exchange sealing rings. coupled position. At uncouples position, compres sed air escapes at coupling head. Valve leaking. Check valves and valve seats, exchanging if necessary. Not enough compressed air is reaching trailer. Pin of opposite coupling head is not pressing fully on valve. Exchanging coupling head with pin. Strainer is choked. Clean strainer. At coupling head special ver sion compressed air escapes from valve hole at disconnected position. Valve body leaking. Clean valve or exchange coup ling head.
Coupling heads, dual-line After coupling up, compressed air escapes at sealing surfaces during full brake application. Sealing surfaces defective. Exchange sealing rings. Coupling heads lock unsatis-fac torily. Retainer worn out. Exchange retainers on both coupling heads. After disconnecting, compressed air escapes at supply head. Valve leaking. Strainer choked. Clean or exchange valve. Clean strainer. 2/2-way valve break-away valve Compressed air escapes at breather hole. Valve leaking. Exchange valve. When brakes are fully applied, pressure in supply line does not drop to 1 .5 bar within 2 seconds. Restrictor orifice, in valve too large, or piston stiff.
Check valve, exchanging if ne cessary. 3/2-way valve changeover valve With tractor unit working alone, compressed air escapes at brea ther hole throughout full brake li i Valve leaking. Exchange valve.