Battery 54-1 A. Remove and install battery The terminals should be tightened good, dirty or oxidised ones are often the reason for bad functioning of electrical system. The current flow can be interrupted by loose terminals. Coat the terminals from time to time with acid protection grease Ft 40 v 1 from Bosch to avoid oxidise. 1. Remove lock screws on battery box cover and cover itself. 2. Disconnect and remove the battery terminals. 3. Remove battery. The inside of the terminal should not be greased with acid protection grease. 4. Install vice-versa. Remark: Attention: When connecting, do not mix up the + and - terminals marked.
When installing and connecting a battery, look out for the following: Avoid spark formation, explosion danger, cover terminals with an insulating plate. Before connecting terminals on battery, clean same with alcohol or soda solution. B. Battery 1. Keep battery always dry and clean. Check acid level and density as per our tub sketch. 2. Do only clean battery outside, when battery acid filler plugs are screwed in. Ventilation holes must be open, to allow the gas formation to escape while the battery is loaded when engine is running. Never use an open light to check the battery, always use a flash light. Picture 54-i/i Check acid level 3. The acid nust be approx.
10-12 mm over the upper edges of the plates. = Glas lube 2 = Mark for acid level