mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

PTO Shaft on Type 421 and 411 55-1 A. Remove anti install shaft If the grooved spline and sleeve is parted, the universals must be lined up again to have the same position of the universal joints before put together again. Arrow points to arrow. Remark: As of chass. no. 411.850 2175 the shafts and the bearings of pto’s have been re-enforced. The formerly 10 hole connection Picture 55-1/1 hase been changed into one with wedge and only 4 hole connection. The not yet re-enforced pto. shaft bearings still have the 3 mounting screw connection between the bearing housing and the frame. Picture 55-1/1 I. Remove and install front plo. 1. Remove 4 hex.

head screws on the drive flange of the transmission, look out for toothed washers. Remove the clamp. 3. Pull out complete pto. with pto. bearing to the front. 2. Remove 1 hex. screw M 10 and 2 hex. nut M 10 on front pto. bearing, also watch the toothed washers. 4. Installation is done vice-versa. II. Remove and install rear pta. 1. Tilt dump bed to the right and secure. drive flange, do sam on flange of rear pto. bearing. Look out for toothed washers. Now remove the shaft, bearing remains on frame. On vehicles without a dump bed remove the rear wall and the inserted floor piece. 2. Remove 4 hex. screws M 8 on transmission 3. Installation is done vice-versa.