5. Disconnect the middle pto. bearing on mounting bracket one hex. screw M 10 and 2 hex. nuts look out for toothed washers. Remove U-clamp and pto. bearing. Remark: On type 411, the same mounting proce dure as described under pos. no. 5. 6. Remove rear pto. bearing 4 hex, head screws with nuts M 10. 7. Installation is done vice-versa. B. Remove, install and repair pto. bearing Picture 55-1/2 1. After the pto. shafts are disconnected on the flange of front and rear pto. bearings, remove one each hex. screw M 10 and 2 each nut from front and rear bearing. Take off bearings complete. 6. Press out shaft from the flange side. 7. Remove sealing rings on both ends of bearing housing.
Prior, remove the shrinkage ring. 8. Remove the lock ring on the side of the oil filler hole. Remark: On the type 421, the rear pto. bearing is 9. Push out grooved ball bearing, use arbor.