mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Remove, Install and Partially Repair Starter on Type 411 15-1.1 A. Remove and install starter 1. Remove ground cable on battery. 2. Remove starter cable 30. 3. Loosen electric wire on connection 50. 4. Loosen connecting bolts of starter on crank case housing and remove starter, use tool no. 63658900 01 00. 5. Installation is done vice-versa. Picture 15-1.1/1 1 = Connection 30 2 = connection 50 3 = connection bolt for magnetic switch B. Partially repair starter Remark: 6. Decotter castled nut in front of the starter pinion, remove same and the lock ring too.

For the repair of the starter, the same rules as of the generator do apply, that means bring starter to the nearest Bosch Service Station. 7. Remove armature out of its front mounting bearing. The description of starter repair only goes for changing of brushes and brush springs as well as changing of the starter pinion. 8. Pull down shifting fork. Starter pinion can now be removed. 1. Remove protection cover plate forcollector. 9. Clean and check collector, if necessary use polish linnen to clean, also clean the grooves between the bars otherwise short circuit. 2. Tighteningscrew hex. nut for el. wire from magnetic switch to the starter motor to be loosend. 3.

Lift up brush pressure spring, and remove the brushes. 10. Check starter pinion and if necessary, renew. 4. The 2 long screws to be taken out, remove bearing cover1 mci. armature before taking out, mark. 11. Check also and if necessary, renew the brush pressure springs and the brushes