mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Remove and Install Generator on Type 421 15-2 Three-phase generator r--n I. In general The generator is suppling the direct current, converted by the silicon rectifier into direct needed for the electrical system in the vehicle, L - - - - J current diode in bridge position. Converting element regulator, the operating voltage is a.c. into d.c. By means of a two-contact-one- regulated. The generator itself regulates the max. voltage, the rectifiers are taken over the 0+ 1DF 0- functioning of the return current switch. The 0 generator is pre-exited by the battery and during the operation the exiting is done by an installed 3 exiting diode in the coil.

The three-phase generator needs no main tenance. To avoid great damages, look out for the following: 1. As long as the engine is running, do not remove ignition key or the terminals on the battery, the connection on the generator itself, or the plug of the regulator. Other wise the diodes will be damage by the in ductive voltage peak. 2. For the same reason it is not permissible to the battery are not connected pull a UNIMOG as long as the cables on when loading a vehicle. Picture 15-2/1 3. The three-phase generator must and should not be polarized. The pre-exiting is sufficient 1 = Regulator 2 Plug connections as long as the control light is on.

3 = 5crew connections 4 = Loading warning light S = Rectifier 6 Battery 7 = Threephase coil = Exting coil runner 4. By no means mix-up the terminals or the connections on the generator, regulator or starter. Attention: Implements with seperate main