mercedes-benz — Mercedes-Benz Unimog 421-411 Service Workshop Manual Volume 1

Remove, Install and Partially Repair Generator on Type 411 15-2.1 The rated output of the generator is 130 W. The generator can be overloaded continously up to 50 %. The reserve is to charge the battery even when consumers are shut-on head lights at night. Continous consumers are the ones in operation usually all night: Head light, tail light, licens plate light etc. A. Remove and install generator Remark: It might be a good idea to have generator 1. Disconnect ground cable on battery. run as an engine for a little while, therefore 2. Disconnect wires on generator. connect no. 61 with 51. 3. Remove set screw on bracket of generator Do this before V-belt is mounted. and take off V.belt, 4.

Remove both screws on the carrier of If the generator runs in the same direction as generator mounting bracket, take off the engine does, this is the right direction and generator. generator has the correct polarity too. Provided 5. Installation is done vice-versa, the battery is connected in the right way. B. Partially repair generator The generator should only be repaired in the in the bearing cover and pull-off the ball own shop if no Bosch Service Station is around, bearing. Use puller 000589203300. Otherwise give generator out for repair. 8. If collector shows grooves, turn down 1. Loosen and remove collector protection slightly. strap. The isolation between the collector bars 2.

Lift brush springs and brushes too, clamp and the bars itself must be set-back by brushes with springs to hold, dont brake 0.6 mm. If this is not the case, use a collec brushes. For saw for cut-in. Clean collectar. 3. Remove both long screws, also the bearing 9. Clean brushes with clean rag. If worn out, cover on the drive side, including the coil, renew. Before pulling out, mark. The brushes should glide in the brush 4. Loosen mounting screw of the plus brush holder easily and the springs should press