. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE (F)Front of the machine 3. Remove dipstick (G), then remove drain plug (P) and drain the oil. After draining the oil,tighten drain plug (P). 4. Add oil through the holder of dipstick (G). After adding the oil, insert dipstick (G). 5. Remove any dirt or dust stuck to breather (5), then wash with clean diesel oil or flushing oil. If it cannot be cleaned completely, replace with a new part. 6. Install undercover (2), then close engine side cover (1) on the left side of the machine. 4 - 76 2) Hold c over ( 2) and gradually remove 2 bolts (4) at the rear of the chassis. (Be careful when doing this.
Rain water may run ou Lower seen a cove t the r (2) top.