EPA07 SERIES 60 ENGINE OPERATOR'S MANUAL DDEC VI SYSTEM Detroit Diesel Series 60 engines equipped with DDEC are identified by the letter “G” in the sixth position of the model number. Example: 6067H G 6E. The Series 60 engine for 2007 is equipped with DDEC VI. The Accelerator Pedal Assembly (AP) eliminates the need for any throttle linkage. Motor Control Module DDEC VI regulates the fuel injection quantity and timing using solenoid valves, allowing extremely low-emission operation. Besides the engine and its related sensors, the system has two control modules: The MCM (see Figure 12) is typically located on the left-hand side of the engine.
The MCM processes the data received from the CPC, for example the position of the accelerator pedal, engine brake, etc. The Motor Control Module (MCM) The Common Powertrain Controller (CPC) located under the right-hand dash panel The two control units are connected by a proprietary datalink through which all necessary data and information can be exchanged. The CPC broadcasts all information on the J1587 and J1939 datalinks, where it can be read by the diagnostic tool. Figure 12 MCM The MCM monitors both the engine and the datalink. When a malfunction or other problem is detected, the system selects an appropriate response; for example, the emergency running mode may be activated.
These data are evaluated together with the data from the sensors on the engine, such as coolant and fuel temperature and oil and charge pressure. The data is then compared to the characteristic maps or lines stored in the MCM. All information subject to change without notice. 33 DDC-SVC-MAN-0006 Copyright © 2009 DETROIT DIESEL CORPORATION