Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE lbft) 4 - 81 CLEAN BREATHER of step (2) to remove step (2). to remove cover (4). 1. 2. 3. 1. Remove bolts (1) of step (2) to remove s tep (2 2. Remove bolts (3) to remove cover (4). Remove breather( 5), then u se clea n diesel fuel or flushing fluid CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS Please ask y our Kom atsu distributor to chec k the tightening of the clamps between the ai r cleaner - turbocharge - aftercooler - engine.

CHECK FOR LOOSE ROPS MOUNT BOLTS Check that t he bolts a re not loo se and that th ere i s no damage If any bolt is loose, tig hten it to t he following t orqu If there is an y damage , replace the bol t with a genuine Komatsu part. (Machine eq uipped wi Bolt (1 ) (4 ea ch on rig ht and left sides) Tightening torque: 24 5 to 309 N m (25 t o 31.5 kgm , 180.8 to 227.8 INSPECTION OF AFTER-COOLER CIRCUIT FOR LOOSENED BOLTS AND NUT Check each clamp for loosenin g. If any clam p is f ound loosened, tighten it further.