Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) Crimp Oetiker clamp using OETIKER PLIERS (P/N 295 000 070) . PTO COUPLING PTO Coupling Removal Lock crankshaft. Refer to CYLINDER BLOCK sub- section for the procedure. Remove PTO seal as described in previous proce- dure. Unscrew coupling from crankshaft using IM- PELLER REMOVER/INSTALLER (P/N 529 035 820) . PTO Coupling Installation For installation, reverse the removal procedure. However, pay attention to the following. Apply LOCTITE 648 (GREEN) (P/N 413 711 400) on threads and torque PTO coupling to 250 N•m (184 lbf•ft).
STARTER DRIVE BEARING 529035820 IMPELLER REMOVAL TOOL NOTICE Apply engine oil to the removal tool to protect the seal located within the PTO cou- pling. smr2009-022-009_a 1. Starter drive bearing Starter Drive Bearing Removal Remove PTO housing, see procedure in this sub- section. Remove starter drive bearing from PTO hous- ing using the BLIND HOLE BEARING PULLER SET (P/N 529 036 117) . smr2009-022-008_a TYPICAL 1. Impeller removal tool NOTE: PTO coupling has left hand threads. PTO Coupling Inspection Inspect seal within coupling, if it is brittle, cracked or hard, replace it. Check coupling for worn or damaged splines. Re- place as required. smr2009-022 77