Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) Reinstall LH engine support. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on screw threads then torque to 24 N•m (18 lbf•ft). Remove block under engine. Install both rear engine support screws. Carry out an engine alignment, refer to the ENGINE REMOVAL AND INSTALLATION subsec- tion. PTO Seal Removal Place rags under PTO housing to prevent spillage. If spillage occurs, clean immediately with PULLEY FLANGE CLEANER (P/N 413 711 809) to prevent oil stains. NOTE: Note position of seal and orientation of Oetiker clamp for installation. Remove the Oetiker clamp retaining the seal to the PTO housing.

NOTICE An engine alignment procedure must be carried out to ensure proper engine alignment or severe component damage may occur. Install all remaining parts, reconnect hoses and electrical connectors. Refer to applicable subsec- tions for procedures and specific details (torques, service products or special instructions). Refill engine with oil and cooling system with coolant. Refer to LUBRICATION SYSTEM and COOLING SYSTEM subsections. PTO SEAL PTO Seal Inspection Inspect the PTO seal on the PTO housing. If brit- tle, hard or damaged, or if you see a sign of oil leakage, replace it. Inspect ball bearing within PTO seal for excessive play and smooth operation.

Replace PTO seal if oil seal or ball bearing is dam- aged. smr2009-022-007_a TYPICAL 1. Oetiker clamps 2. PTO seal Pull seal from PTO housing. PTO Seal Installation Insert a NEW Oetiker clamp over the seal. Push seal onto PTO housing. Be sure to align seal and clamp as noted at removal. NOTICE When installing PTO seal on super- charged engines, make sure to position the Oetiker clamps as illustrated. smr2009-022-006_a 1. PTO seal 1. Oetiker clamps 76 smr2009-022