Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) smr2005-034-100_a TYPICAL 1. Thrust washer 2. Disc springs 3. Starter drive assembly NOTE: When installing a NEW starter drive as- sembly, oil the shaft and gear splines with engine oil. Install a new PTO housing gasket. NOTE: When installing the PTO housing, you will need to rotate the oil/water pump shaft slightly to align it with the balance shaft for proper insertion. smr2009-022-001_b 1. Screws M6 x 35 2. Screws M6 x 85 NOTE: Install the CPS harness retaining clamp at the position noted during the PTO housing removal.

NOTICE Pay particular attention to the PTO housing gasket alignment to ensure that it does not get pinched, or slide out of its sur- face contact area. Never force housing when installing it. If there is a strong resistance, re- move housing and check oil/water pump shaft alignment and starter gear drive alignment. NOTICE Ensure the starter drive gear shaft is well aligned when engaging it in the PTO hous- ing needle bearing. smr2009-022-004_a 1. CPS harness retaining clamp Install the PTO housing screws finger tight, then torque them to 9 N•m (80 lbf• in ) as per sequence numbered in the following illustration. smr2009-022-002_a 1.

Pay attention that gasket remains properly positioned on this surface Refer to the following illustration to identify the locations of the various housing screws. smr2009-022-001_c smr2009-022 75