Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) PTO Housing Inspection Inspect PTO housing for cracks or any other dam- ages. Replace if necessary. Inspect the needle bearing in the PTO housing used to support the starter drive assembly shaft. NOTE: Clean all disassembled metal components in a non-ferrous metal cleaner. WARNING Wear safety glasses and work in a well ventilated area when working with strong chemical products. Also wear suitable non- absorbent gloves to protect your hands. smr2009-022-001_a 1. PTO housing 2. CPS harness retaining clamp 3. CPS Inspect oil strainer for contaminants, debris or other particles. Clean as required. NOTE:
Note position of the CPS harness retaining clamp position as illustrated above for reinstalla- tion. Remove PTO housing from engine. NOTICE To prevent damaging contact sur- faces, be sure to use prying lugs to separate PTO housing from engine. NOTE: Carefully separate PTO housing from en- gine using two flat screwdrivers prying equally on opposite sides of the housing and at the same time. Proceed slowly to prevent starter gear disc springs and washer from falling down into bilge area. 8 9 1. PTO oil strainer PTO Housing Installation For installation, reverse the removal procedure. However, pay attention to the following.
Apply lubricants, sealers or thread locker as spec- ified in exploded view. Apply torques as specified in exploded view. Position the disc springs and thrust washer onto the starter drive assembly shaft as per following illustration. smr2005-034-002_a 1. Disc springs 2. Washer 3. Starter drive gear Remove PTO housing gasket and discard. 74 smr2009-022