Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) Slightly lift aft end of engine and insert a safely block under the engine to secure it in this position. Remove LH rear engine support. smr2009-016-015_b 1. Magneto connector 2. ECM 3. Throttle body Place rags under PTO housing to prevent oil spillage. NOTE: Up to 250 ml (8 U.S. oz) of oil could flow out when removing PTO housing. If spillage oc- curs, clean immediately with the PULLEY FLANGE CLEANER (P/N 413 711 809) to prevent oil stains. Remove both rear engine support screws. TYPICAL 1. Engine support Remove water pump housing, refer to COOLING SYSTEM subsection. smr2007-016-003_c 1.

Water pump housing smr2009-016-020_b RIGHT SIDE OF VEHICLE 1. Rear engine support screw Remove PTO housing retaining screws. smr2009-016-022_b LEFT SIDE OF VEHICLE 1. Rear engine support screw smr2009-022 73