Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) smr2009-016-015_b 1. Magneto connector 2. ECM 3. Throttle body 529036117 Starter Drive Bearing Installation Prior to assembly grease starter drive bearing with ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021) . Install starter drive bearing in PTO housing using the STARTER DRIVE SEAL PUSHER (P/N 420 876 502) and the HANDLE (P/N 420 877 650) . Install the 3-PIN MAGNETO HARNESS ADAPTER (P/N 529 036 016) onto the magneto connector. NOTE: Do not connect the magneto harness adapter to the vehicle harness connector. 420876502 Set multimeter to Vac scale. Start engine.

Connect multimeter between each pair of YEL- LOW wires as per following table. Measure volt- age between each pair of wires. 529036016 420877650 STATOR Stator Output Voltage Test Disconnect the magneto wiring harness connec- tor. This connector is located between the ECM and the throttle body. smr2009-022-101_a STATOR OUTPUT VOLTAGE TEST 1. Connect adapter to magneto stator connector 2. Leave vehicle harness disconnected Read voltage as per following table. 78 smr2009-022