Section 02 ENGINE Subsection 07 (PTO HOUSING AND MAGNETO) If voltage is lower than specification, carry out a STATOR CONTINUITY TEST and a STATOR INSU- LATION TEST. See procedures in this subsection. Stator Continuity Test Disconnect the magneto wiring harness connec- tor. This connector is located between the ECM and the throttle body. smr2009-022-101_b STATOR CONTINUITY TEST 1. Connect adapter to magneto stator connector 2. Leave vehicle harness disconnected Read resistance. If any result is out of specification, replace stator. Stator Insulation Test Disconnect the magneto wiring harness connec- tor. smr2009-016-015_b 1. Magneto connector 2. ECM 3.
Throttle body Install the 3-PIN MAGNETO HARNESS ADAPTER (P/N 529 036 016) onto the magneto connector. NOTE: Do not connect the magneto harness adapter to the vehicle harness connector. Set multimeter to . Connect multimeter between each pair of YEL- LOW wires. smr2009-016-015_b 1. Magneto connector 2. ECM 3. Throttle body Install the 3-PIN MAGNETO HARNESS ADAPTER (P/N 529 036 016) onto the magneto connector. NOTE: Do not connect the magneto harness adapter to the vehicle harness connector. Set multimeter to . Connect multimeter between any YELLOW wire and engine ground. smr2009-022 79 STATOR OUTPUT VOLTAGE TEST TEST ENGINE SPEED TERMINAL VOLTAGE (AC) 4000 RPM 1 and 2 Approx.
50 Vac 1 and 3 2 and 3 STATOR CONTINUITY TEST TERMINAL RESISTANCE @ 20°C (68°F) 1 and 2 0.1 - 1 1 and 3 2 and 3