Section 02 ENGINE Subsection 10 (CYLINDER HEAD) A. Measure rocker arm shaft diameter here 1. Rocker arm shaft 2. Rocker arms (exhaust side) 3. Rocker arm (intake side) Rocker Arm Inspection Inspect each rocker arm for cracks and scored fric- tion surfaces. If so, replace rocker arm assembly. Check the rocker arm rollers for free movement, wear and excessive radial play. Replace rocker arm assembly as necessary. Any area worn excessively will require parts re- placement. Verify and clean oil orifices to ensure a good rocker arm shaft lubrication. smr2008-017-006_a 1. Rocker arm (intake side) 2. Rocker arm (exhaust side) 3. Rollers A. Rocker arm inside diameter 1.
Oil orifices from the camshaft to the rocker arm shaft, then to the rocker arms and finally to the valve adjustment Measure rocker arm inside diameter. If diameter is out of specification, change the rocker arm as- sembly. Rocker Arm Installation For installation, reverse the removal procedure. Pay attention to the following details. NOTE: The rocker arm shaft can only be installed in one specific position. Therefore the camshaft has to be positioned with its locking pin when the piston of cylinder no. 3 is on ignition TDC. 1. Lock camshaft. Refer to CAMSHAFT in this subsection. 2. Make sure the position lines on oil separator cover are lined up as shown in the following il- lustration.
Press the hydraulic lifter with your thumb. If the hydraulic lifter can be fully pressed in, replace rocker arm. Lifter must turn freely in rocker arm bore. Otherwise, replace. Rocker Arm Shaft Check for scored friction surfaces, if so, replace parts. Measure rocker arm shaft diameter. smr2009-025 135 ROCKER ARM SHAFT DIAMETER NEW 19.980 mm - 19.993 mm (.7866 in - .7871 in) SERVICE LIMIT 19.965 mm (.786 in) ROCKER ARM INSIDE DIAMETER NEW 20.007 mm - 20.020 mm (.7877 in - .7882 in) SERVICE LIMIT 20.035 mm (.7888 in)