Section 02 ENGINE Subsection 10 (CYLINDER HEAD) smr2009-025-006_a 1. Position lines 3. Apply engine oil on rocker arm shaft. 4. Position the rocker arm shaft with the notches on top. 7. Retorque screws to 20 N•m (15 lbf•ft). 8. Finish tightening screws turning an additional 90° rotation with a torque angle gauge. 1. Rocker arm shaft 2. Rocker arm shaft notches 1. Rocker arm shaft screw 2. Torque angle gauge 5. Install NEW rocker arm shaft screws. Torque as per following procedure: CAMSHAFT TIMING GEAR NOTE:
Although it is not necessary to position crankshaft to TDC for disassembly, it is a good practice to do it, as a troubleshooting step, to know before disassembly if valve timing was appropriate. NOTICE This assembly uses stretch screws. As the screws have been stretched from the previous installation, it is very important to use new screws at assembly. Failure to re- place screws and to strictly follow the torque procedure may cause screws to loosen and lead to engine damage. Camshaft Timing Gear Removal Lock crankshaft, refer to CYLINDER BLOCK sub- section. Remove CYLINDER HEAD COVER, see proce- dure above in this subsection. Lock camshaft. Refer to CAMSHAFT in this sub- section.
Remove the oil separator cover. Refer to LUBRI- CATION SYSTEM subsection. 6. Torque screws at first to 10 N•m (89 lbf• in ) ac- cording to following sequence. 136 smr2009-025