Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 10 (CYLINDER HEAD) Remove the chain tensioner. Refer to CYLINDER BLOCK subsection. Remove the chain guide. Remove the Allen screws securing the camshaft timing gear. Remove the camshaft timing gear. smr2008-017-007_a 1. Chain guide 2. Allen screws 3. Camshaft timing gear 1. Good (with 1503 aligned) 2. Never Install timing chain. Refer to CYLINDER BLOCK subsection. Ensure chain guides are in place. Loosely install timing chain screws. Install chain tensioner. NOTE: There can be 2 different positions to install the timing gear on the camshaft. Basically both positions are working well, since the camshaft and crankshaft are locked in their proper position.

Due to some tolerances, there could be one po- sition which fits better than the other one. To check this, perform the following test. Check if timing chain screws are still loose. If screws are squeezed by the timing gear, remove the chain tensioner again and rotate timing gear by one tooth clockwise. Then install the chain tensioner again. One at a time, remove timing chain screws and apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads. Tighten timing chain screws to 9 N•m (80 lbf• in ). NOTE: Secure timing chain with a retaining wire. Camshaft Timing Gear Inspection Check camshaft timing gear for wear or deteriora- tion.

If gear is worn or damaged, replace it as a set (camshaft timing gear and timing chain). For crankshaft timing gear, refer to CYLINDER BLOCK subsection. Camshaft Timing Gear Installation For installation, reverse the removal procedure. Pay attention to the following details. NOTICE Improper camshaft timing will dam- age engine components. Make sure camshaft and crankshaft are still locked. If not, lock them before beginning this procedure. Install the camshaft timing gear with the writing visible, i.e. to be able to see the position lines when looking from outside of engine.

NOTICE Crankshaft and camshaft must be locked on TDC position to place camshaft timing gear and timing chain in the proper position. To double check, take a look at the timing gear lines. They must be parallel to the cylinder head surface. smr2009-025 137