Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 10 (CYLINDER HEAD) Camshaft Removal Remove the CAMSHAFT TIMING GEAR, see pro- cedure in this subsection. Remove the ROCKER ARM, see procedure in this subsection. Remove the camshaft lock to remove the camshaft. 1. Position lines NOTICE Ensure to remove locking tools when finished. Install all other removed parts. CAMSHAFT Camshaft Locking Procedure 1. Remove CYLINDER HEAD COVER, see proce- dure in this subsection. 2. Lock crankshaft, refer to procedure in CYLIN- DER BLOCK subsection. 3. Lock camshaft using the CAMSHAFT LOCKING TOOL (P/N 529 035 839) . 1. Camshaft lock 2.

Camshaft Camshaft Inspection Check each lobe and bearing journal of camshaft for scoring, scuffing, cracks or other signs of wear. Measure camshaft bearing journal and lobe height using a micrometer. Measure clearance between both ends of camshaft and cylinder head. 529035839 4. Make sure the position lines on oil separator cover are lined up as shown in the following il- lustration. A. Camshaft lobe (exhaust valves) B. Camshaft lobe (intake valves) C. Camshaft bearing journal D. Camshaft bearing journal engine front smr2009-025-007_a 1. Camshaft locking tool 2.

Position lines 138 smr2009-025 CAMSHAFT LOBE HEIGHT — EXHAUST VALVE NEW 31.699 mm - 31.809 mm (1.248 in - 1.2523 in) SERVICE LIMIT 31.670 mm (1.2469 in) CAMSHAFT LOBE HEIGHT — INTAKE VALVE NEW 31.480 mm - 31.590 mm (1.2394 in - 1.2437 in) SERVICE LIMIT 31.450 mm (1.2382 in)