Section 02 ENGINE Subsection 10 (CYLINDER HEAD) Drain coolant, refer to COOLING SYSTEM sub- section. Unscrew blow-by valve from cylinder head. Refer to LUBRICATION SYSTEM subsection. Unplug the camshaft position sensors (CAPS). Unplug the coolant temperature sensor (CTS). Disconnect bleeding hose. Disconnect the cylinder head outlet hose. Replace parts that are not within specifications. Camshaft Installation For installation, reverse the removal procedure. Pay attention to the following details. Grease the camshaft bearing journals well by us- ing the ISOFLEX GREASE TOPAS NB 52 (P/N 293 550 021) or a similar product. Install camshaft then place the camshaft lock in the slot.
smr2009-025-008_a 1. Coolant temperature sensor (CTS) 2. Bleeding nipple 3. Cylinder head outlet hose Remove the exhaust manifold. Refer to EX- HAUST SYSTEM subsection. Unscrew the oil filler tube support from cylinder head. 1. Camshaft lock position smr2009-025-009_a 1. Retaining screws 2. Oil filler tube support For other parts, refer to the proper installation pro- cedures in this subsection. Remove the CAMSHAFT TIMING GEAR, see pro- cedure in this subsection. Remove the cylinder head screws M6. CYLINDER HEAD Cylinder Head Removal Lock crankshaft, refer to CYLINDER BLOCK sub- section.
smr2009-025 139 CAMSHAFT BEARING JOURNAL NEW 39.892 mm - 39.905 mm (1.5706 in - 1.5711 in) SERVICE LIMIT 39.860 mm (1.5693 in) CAMSHAFT BEARING JOURNAL (ENGINE FRONT) NEW 24.939 mm - 24.960 mm (.9819 in - .9827 in) SERVICE LIMIT 24.910 mm (.9807 in) CAMSHAFT BEARING INNER DIAMETER NEW 40.000 mm - 40.016 mm (1.5748 in - 1.5754 in) SERVICE LIMIT 40.050 mm (1.5768 in) CAMSHAFT BEARING INNER DIAMETER (ENGINE FRONT) NEW 25.000 mm - 25.013 mm (.9843 in - .9848 in) SERVICE LIMIT 25.050 mm (.9862 in)