Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 10 (CYLINDER HEAD) smr2009-025-010_a 1. Oil orifices Cylinder Head Inspection Check for cracks between valve seats or other damages, if so, replace cylinder head. Check cylinder head mating surface for flatness, using a straight edge. 1. Cylinder head screws M6 Remove the cylinder head screws M11 securing cylinder head to cylinder block. smr2006-016-063_a 1. Cylinder head 2. Flat bar 3. Feeler gauge 1. Cylinder head screws M11 Pull up cylinder head. Remove gasket. Check cylinder head warpage. Cylinder Head Cleaning Remove carbon deposits from combustion cham- ber, exhaust port and piston top.

Clean cylinder head, especially cylinder head screw surface from oil spillage. Blow out the oil orifices and check if they are not clogged. If warpage exceeds specification, resurface the cylinder head as follows. Use a 400 - 600 grit wet sandpaper on a surface plate and gently grind off the mating surface. NOTE: To ensure an even surface, rotate cylinder head several times during resurfacing. Replace cylinder head, if resurfacing fails. Cylinder Head Installation For installation, reverse the removal procedure. Pay attention to the following details. Ensure dowel pins are in place. Install NEW cylinder head gasket. 140 smr2009-025 CYLINDER HEAD WARPAGE Maximum 0.15 mm (.006 in)