Bombardier Recreational Products Inc. (BRP) Sea-Doo RXT iS255 GTX LIMITED — Print Preview - C:\DOCUME~1\coderma\LOCALS~1\Temp\.aptcache\smr2009Piranhaen6/tfa03092

Section 02 ENGINE Subsection 10 (CYLINDER HEAD) NOTICE Each installation of the cylinder head requires a new cylinder head gasket. Us- ing a gasket twice will cause engine damage, even if the engine had not run. Apply LOCTITE 243 (BLUE) (P/N 293 800 060) on threads of screws M6. Install screws M6 and manually tighten them. Install NEW screws M11and tighten them manu- ally. NOTICE This assembly uses stretch screws. As the screws M11 have been stretched from the previous installation, it is very important to replace the old screws by new ones at assem- bly. Failure to replace screws and to strictly fol- low the torque procedure may cause screws to loosen and lead to engine damage. 1.

Cylinder screws M11 2. Angle torque wrench Using the following sequence, tighten screws as described below. Remove all locking tools. Install all removed parts. VALVE SPRINGS Valve Spring Removal Remove rocker arm shaft. Refer to ROCKER ARM procedure in this subsection. Remove CYLINDER HEAD, see procedure in this subsection. Compress valve springs, using the VALVE SPRING COMPRESSOR (P/N 529 035 724) and the VALVE SPRING COMPRESSOR CUP (P/N 529 036 073) . smr2005-036-002_a 1. First torque screws M11 to 40 N•m (30 lbf•ft). 2. Then tighten screws M11 turning a 120° rota- tion with a torque angle gauge and finish tight- ening with an additional 90° rotation. 3.

Torque screws M6 to 9 N•m (80 lbf• in ). 5290357242 VALVE SPRING COMPRESSOR 529036073 VALVE SPRING COMPRESSOR CUP smr2009-025 141