Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) 202 smr2009-029 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P0268 ECM Injector 3 shorted to battery Damaged injector, damaged circuit wires, damaged connector or damaged ECM output pins Check for 11.4 to 12.6 ohms between engine connector pin 3 and ECM connector pin A-J1. Check for 12 volts on pin 2 of injector connector. Check fuse 9 (refer to WIRING DIAGRAM). Check for damaged circuit wires. Refer to the Service Manual for more details.
P0300 ECM Multiple misfire detected P0301 ECM Misfire cylinder 2 (physical cylinder 1) P0302 ECM Misfire cylinder 0 (physical cylinder 2) P0303 ECM Misfire cylinder 1 (physical cylinder 3) P0325 ECM Knock sensor fault Damaged sensor, damaged circuit wires, damaged connector or damaged ECM output pins Bring engine to 5000 RPM. If fault code appears then check for approximately 5 Mohms between system circuits A-C3 and A-G2. Refer to the Service Manual for more details. P0335 ECM Crankshaft signal error Damaged sensor, damaged circuit wires, damaged connector, damaged ECM pins or damaged tooth wheel For the CPS, check for 700 to 900 ohms between terminals A-H1 and A-K2 of ECM connector.
Refer to the Service Manual for more details. P0340 ECM Camshaft 1 signal error Damaged sensor, damaged circuit wires, damaged connector, damaged ECM pins or damaged tooth wheel For the CAPS, check for 12 volts on sensor connector pin 3. Check continuity for circuits A-D4, A-E2 and terminal 4 on engine connector. Check fuse 2 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details. P0351 ECM Ignition coil 1 open circuit or shorted to ground or to battery Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 1 and ECM connector pin A-M4. Check for 12 volts on pin 2 of coil connector.
Check fuse 7 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details.