Section 03 ELECTRONIC MANAGEMENT SYSTEMS Subsection 04 (MONITORING SYSTEM AND FAULT CODES) smr2009-029 203 FAULT CODE MODULE DESCRIPTION POSSIBLE CAUSE SERVICE ACTION P0352 ECM Ignition coil 2 open circuit or shorted to ground or to battery Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 1 and ECM connector pin A-M2. Check for 12 volts on pin 2 of coil connector. Check fuse 8 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details.
P0353 ECM Ignition coil 3 open circuit or shorted to ground or to battery Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 3 and ECM connector pin A-M1. Check for 12 volts on pin 2 of coil connector. Check fuse 9 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details. P0354 ECM Ignition Power Stage fault - short circuit to GND/Cylinder 1 Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 1 and ECM connector pin A-M4. Check for 12 volts on pin 2 of coil connector.
Check fuse 7 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details. P0355 ECM Ignition Power Stage fault - short circuit to GND/Cylinder 2 Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 1 and ECM connector pin A-M2. Check for 12 volts on pin 2 of coil connector. Check fuse 8 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details. P0356 ECM Ignition Power Stage fault - short circuit to GND/Cylinder 3 Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 3 and ECM connector pin A-M1.
Check for 12 volts on pin 2 of coil connector. Check fuse 9 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details. P0357 ECM Ignition Power Stage fault - short circuit to V+/Cylinder 1 Damaged coil, damaged circuit wires, damaged connector or damaged ECM output pins Check for 0.85 to 1.15 ohms between engine connector pin 1 and ECM connector pin A-M4. Check for 12 volts on pin 2 of coil connector. Check fuse 7 (refer to WIRING DIAGRAM). Refer to the Service Manual for more details.